Basic PIC circuit is not working

I have just begun in the world of micro-controllers, and the first micro-controller. I chose to work with was the PIC from Microchip. The PIC I am using is the PIC16F877A. I am using MPLAP IDE and HI-TECH C. I am trying to make an extremely simple program that turns on an LED. This is the code I am using:

#include<htc.h> #define _XTAL_FREQ 8000000 __CONFIG(UNPROTECT & PWRTDIS & WDTDIS & HS & LVPDIS); int main() { TRISB0 = 0; RB0 = 1; while(1);}

When I hookup the PIC to my circuit the LED does not turn on.

A few other notes about my circuit:

• I am using a 9 volt battery hooked up to a 7805 regulator for the power supply
• I have measured the voltage coming from pin RB0 with a multimeter and it measures 0.0V.

• If there is no problem with my circuit I could have programmed the chip wrong
• My capacitors hooked up with my crystal are 22pf not 22uf
• I have put 100uf capacitors between pins 11 and 12 and between 31 and 32

For more detail: Basic PIC circuit is not working

The post Basic PIC circuit is not working appeared first on PIC Microcontroller.